SectionHeader4
16472869_1855774074635401_6975574372207483653_n
IMG_1409
IMG_1410
IMG_7474
IMG_7476
  • 16472869_1855774074635401_6975574372207483653_n
  • IMG_1409
  • IMG_1410
  • IMG_7474
  • IMG_7476

Front Turn Signals -

Starts at $229.95
Manufatcurer:
DD Custom Cycles
Item Number:
FTS-B / FTS-C / FTS-R
Finish Type:

Product Description: Your custom solution to those stock ugly front signals on the 2015-2016 Harley Davidson Road Glide models. Replace them with the stylish new 6061-T6 3D machined billet aluminum FRONT TURN SIGNALS with SUPER BRIGHT AMBER LED’s. Available in raw, chrome and black finishes. No load equalizer required, ready to install with resistor already in place to calibrate the LED draw so the indicators flash correctly.  Simple to install and requires removal of outer fairing to disconnect the existing stock front turn signals.  These new signals will have the stock OEM style plug on the end that will simply plug into your stock OEM Signal receptacle.  Not only will they will they be signals, but they will also act as running light as well, Dual Function.  Each kit includes two eliminators with installed LED, dual circuit element and resistor all soldered in, and install instructions. Available for purchase online at www.ddcustomcycle.com,  facebook and Instagram.

CALIBRATION INSTRUCTIONS: Once the new signals are installed, you will have to run a BCM calibration. Very simple procedure. Turn the ignition on to the first position, push the hazard button in, turn the key off.  The lights will be blinking in Hazard Mode and leave blinking with ignition off for 3-5 minutes. Once the 3-5 minutes is up, turn the ignition back on to the first position and push the hazard button in again to turn the Hazards off, now turn ignition off and your done!

IF YOU WOULD LIKE THE SIGNALS TO BE SIGNAL ONLY and NOT RUNNING: Snip the blue wire nearest the OEM plug on the new signal harness and cap off the end.

+ Click Here for Install Instructions